11-07-2014 04:07 AM - edited 03-17-2019 12:50 AM
Hi,
We have setup a H323 VGW with 2 E1 circuits attached.
Each circuit has it's own DDI Range applied to it.
The problem we face is that when calling out from the phones with the DDI Range
on circuit 2 it is routing out of circuit 1 and showing an incorrect CLI.
Is there a way to forces calls from DDI Range 1 to route out via 0/0/0
and DDI Range 2 to route out via 0/0/1
Regards
Dominic
Solved! Go to Solution.
11-07-2014 05:55 AM
If this is CUCM then the easiest way is to use steering codes, build separate CSS/PT/Route patterns/Route List/etc for the second group of phones and prefix a digit string at the Route group or route list level, then have different set up dial-peers matching based on those digits that point to the desired PRI.
11-07-2014 06:36 AM
Sure,
dial -peer one points to one trunk group, dial-peer 2 points to another with extra off-net digit:
dial-peer voice 1 pots
trunkgroup Local-PRI
description Local Trunks, Local calls
destination-pattern 81[2-9]..[2-9]......
progress_ind setup enable 3
progress_ind progress enable 8
forward-digits 11
dial-peer voice 2 pots
trunkgroup LD-PRI
description LD Trunks LD calls
destination-pattern 881[2-9]..[2-9]......
progress_ind setup enable 3
progress_ind progress enable 8
forward-digits 11
11-07-2014 05:55 AM
If this is CUCM then the easiest way is to use steering codes, build separate CSS/PT/Route patterns/Route List/etc for the second group of phones and prefix a digit string at the Route group or route list level, then have different set up dial-peers matching based on those digits that point to the desired PRI.
11-07-2014 06:32 AM
Thanks Chris for your help - you wouldn't have an example dial-peer/config I could take a look at by any chance?
11-07-2014 06:36 AM
Sure,
dial -peer one points to one trunk group, dial-peer 2 points to another with extra off-net digit:
dial-peer voice 1 pots
trunkgroup Local-PRI
description Local Trunks, Local calls
destination-pattern 81[2-9]..[2-9]......
progress_ind setup enable 3
progress_ind progress enable 8
forward-digits 11
dial-peer voice 2 pots
trunkgroup LD-PRI
description LD Trunks LD calls
destination-pattern 881[2-9]..[2-9]......
progress_ind setup enable 3
progress_ind progress enable 8
forward-digits 11
11-07-2014 06:41 AM
Thanks Chris - Much Appreciated.
Regards
Dominic
11-11-2014 09:26 AM
Hello Dominice,
Could you share your gateway config detail as I'm also implementing the same setup.
Regards,
Raaj.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: