11-11-2014 01:01 AM - edited 07-05-2021 01:54 AM
Hi guys,
I've configured a brand new 2504 wlc to replace an older model and it's working fine, but some of the hosts are facing problems while trying to connect. They do all the authentication process, but at the end they don't get an IP. I've checked the policy state and it says RUN.
What may be the cause of this?
11-11-2014 09:34 AM
Hi , I dont know which authentication you are using, but the clients should have ip address even before it is placed in to the RUN state.
> What is the WLC version?
>Is "DHCP server required" enabled under WLAN>Advanced
>"debug client mac-address" while you try to connect.
Regards
Dhiresh
**Please rate helpful posts**
11-13-2014 04:24 AM
11-13-2014 03:32 AM
Refer the link for Troubleshoot: http://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/110865-dhcp-wlc.html#tshoot-1
11-16-2014 11:43 PM
Hi,
Read and tried some of the solutions on the article but it didn't help. I don't know what is going on. It only happens on some computers.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide