×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

ASA 5550 SPF Error....

Answered Question
Nov 12th, 2014
User Badges:

Hi all,

My knowledge is pretty limited on the subject, and as a Sys Admin I'm by no means an expert in Cisco Firewalls. But, through a little self teaching and plenty of Google searches I've managed to set up an ASA 5550 on our network, and it's been running fine.

Now though, our circumstances have changed and I need to be able to take advantage of the AFP modules on the ASA 5550. I understand that I can only use ethernet or fiber on each port, not both. That's fine.

But when I try to change any of the GigabitEthernet ports to SFP via "Configure Hardware Properties" , I get the following error:

[OK] Interface GigabitEthernet1/3
      Interface GigabitEthernet1/3
[ERROR] speed 1000 negotiate
 
speed 1000 negotiate
           ^
ERROR: % Invalid input detected at '^' marker.
 
This happens whether I change the option to either negotiate or non negotiate, and the only Duplex option if Auto.
 
This happens whether there is fiber attached or not, and I know the fiber cards/cables involved are all working fine.
 
Any help would be greatly appreciated.
 
Correct Answer by Vibhor Amrodia about 2 years 9 months ago

Hi,

Which version of ASDM are you running ?

Would you be able to try it from the CLI and see if that works ?

Thanks and Regards,

Vibhor Amrodia

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Vibhor Amrodia Thu, 11/13/2014 - 03:11
User Badges:
  • Cisco Employee,

Hi,

Which version of ASDM are you running ?

Would you be able to try it from the CLI and see if that works ?

Thanks and Regards,

Vibhor Amrodia

Actions

This Discussion

Related Content