Solved: CLI command to asign the primary controller name and IP from the master controller.

Mark Shuck · ‎11-13-2014

I´m looking for the CLI command to asign the primary controller name and IP from the master controller. So as AP's join the master controller, I can move them to their new Controller. I would like to do this thru the CLI of the master controller when I rename the AP's with a script that I write after inventorying them. Thanks to all who have any knowledge on this CLI command.

Leo Laohoo · ‎11-13-2014

Command: config ap primary <WLC name> <AP Name> <WLC Management IP address>

View solution in original post

Leo Laohoo · ‎11-14-2014

Hi Mark,

Can you please mark this post as "Answered" if the recommendation has fixed the issue?

View solution in original post

Leo Laohoo · ‎11-13-2014

Command: config ap primary <WLC name> <AP Name> <WLC Management IP address>

Mark Shuck · ‎11-14-2014

Leo Laohoo

Thanks so mush it's a lot easier to assign controller to a large group of new AP's this way.

I used this command from the master controller to change them to the NEW controller.

and it works GREAT...

(Cisco Controller) >config ap primary-base <WLC name> <AP Name> <WLC Management IP address>

Leo Laohoo · ‎11-14-2014

Hi Mark,

Can you please mark this post as "Answered" if the recommendation has fixed the issue?