cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
173
Views
0
Helpful
1
Replies

access wlc froma network defined on the wlc

alessandro.dona
Level 3
Level 3

Hi Guys,

i have a wlc 2504 with 7.6.130

My management ip address is 192.168.1.1/24 and i have an interface on the wlc with ip address 192.168.2.1

From a PC(wired) with ip address 192.168.2.x (network are routed) i cannot access https://192.168.1.1 when i configure on the wlc an interface with ip address 192.168.2.1

It's look like i cannot access wlc from a network defined on the wlc.

Can you help me in resolving this issue?

1 Accepted Solution

Accepted Solutions

Stephen Rodriguez
Cisco Employee
Cisco Employee

That is by design. The WLC does not allow access from a configures interface other than management by default. 

 

If you need to access the WLC from a configures interface other than management you need to issue the command:

config network mgmt-via-dynamic-interface enable

 

HTH,

Steve

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

View solution in original post

1 Reply 1

Stephen Rodriguez
Cisco Employee
Cisco Employee

That is by design. The WLC does not allow access from a configures interface other than management by default. 

 

If you need to access the WLC from a configures interface other than management you need to issue the command:

config network mgmt-via-dynamic-interface enable

 

HTH,

Steve

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: