vWLC after restart "press any key"

mlieber · ‎03-02-2015

Hi,

is it required to press any key after restarting a virtual controller on VM console?

If yes, is there an option to automating this process so that the controller starts without pressing a key.

thanks

Martin

Freerk Terpstra · ‎03-02-2015

No, this is not necessary for the vWLC to boot.

Prakash Parvathala · ‎05-12-2015

No need to press any key for vWLC reboot.

Please go through the below deployment guide for vWLC boot process.

http://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/7-5/Cisco_VirtualWirelessController75.html

mohanak · ‎05-13-2015

Refer the link : https://supportforums.cisco.com/discussion/12407606/virtual-wireless-controller-auto-restart-after-power-failure

sobhardw · ‎05-13-2015

The VWLC should always complete the boot process without any intervention. You only have to press a key if you want to use the "VMware console window" as a controller console window.

You can redeploy the VWLC and If problem still persist please contact TAC (tac@cisco.com)