cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
718
Views
0
Helpful
3
Replies

ACS 5.X - GUI Login Issue

nomykhan
Level 1
Level 1

Hi

 

I have installed ACS 5.1 on vmware fusion.

I am successfully able to login via CLI - created more admin users as well.

 

When i try to use the same credentials over the web - it fails . Any clue why this is happening?

3 Replies 3

You might have more luck asking this in the AAA forum

https://supportforums.cisco.com/community/5936/aaa-identity-and-nac

 

--
Please remember to select a correct answer and rate helpful posts

Tushar Bangia
Level 1
Level 1

The default username for Cisco ACS 5.x n above is 'acsadmin', you must have set one when setting up ACS however if you dont remember than you can reset it as below:

 

ACS/admin# acs reset-password
This command resets the 'ACSAdmin' password to its original value.
Are you sure you want to continue?  (yes/no) yes

Password was reset successfully

 

 

Regards,

 

Tushar Bangia

 

Note - Please do rate post if you find it helpful!!!!

----------------------------------------------------------------------------------

 

and the default password for the Cisco ACS GUI is 'default'.

 

Hence post password reset if you try to login via GUI, it will ask you to setup a new password.

 

Regards,

 

Tushar Bangia

 

Note - Please do rate post if you find it helpful!!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: