Hello all I hope I have the right forum.

I inherited a network on site that has a Cisco ie3000 switch in a building I'm not cleared to enter yet. I can see the switch from and ajoining cisco switch but I cannot telnet, Hyperterm, SSH, or web interface into it. I will post the startup below omitting the IP but I know that is not the issue. Can anyone see what I am missing? I know it's not a hop issue as I am 1 hop away. Other switches in my network all can be accessed with no issues.

Switch#sh start
Using 969 out of 65536 bytes
!
version 12.2
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Switch
!
boot-start-marker
boot-end-marker
!
!
!
!
no aaa new-model
system mtu routing 1500
ptp mode e2etransparent
!
!
!
!
!
!
no mac authentication
mac authentication table version 0
spanning-tree mode pvst
spanning-tree extend system-id
!
alarm profile defaultPort
!
!
vlan internal allocation policy ascending
lldp run
!
!
!
interface FastEthernet1/1
!
interface FastEthernet1/2
!
interface FastEthernet1/3
!
interface FastEthernet1/4
!
interface FastEthernet1/5
!
interface FastEthernet1/6
!
interface FastEthernet1/7
!
interface FastEthernet1/8
!
interface GigabitEthernet1/1
 switchport mode trunk
!
interface GigabitEthernet1/2
!
interface Vlan1
 ip address ###.###.###.### ###.###.###.###
 no ip route-cache
!
ip http server
ip sla enable reaction-alerts
!
line con 0
line vty 0 4
 login
line vty 5 15
 login
!
end