cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 
cancel
1152
Views
5
Helpful
0
Replies

Maximum officially supported (TAC) number of nodes in a REP Segment

spoofneted
Level 1
Level 1

I've read various posts about Resilient Ethernet Protocol (REP) sizing limitations (such as "Maximum nodes in a REP segment?"), which all talk about various numbers of Nodes per REP Segment/Ring - 16, 32 and up to 100 - as being tested, but with no hard-and-fast guarantees.

Various Cisco documentation/Technical Presentations mention 16 as the number of REP Nodes that would be officially supported; however, in a pure fibre network implementation (back-to-back Cisco IE2Ks running 1000Base-ZX / 1000Base-EX / 1000Base-LX, with no Transmission Network/OTN), which then connects into a Data Centre-like Rapid PVST+ Layer 2 Domain, can this count be increased?

I realise this may be a "how long is a piece of string" question, but want to ensure that whatever solution we use is to the relevant Cisco TAC standards, and in line with best practice - and ultimately, allows for full exploitation of a fibre ring topology using REP (maximum amount of REP Nodes), while still being supportable at a Third Line level, if any faults had to be escalated up to, say, Cisco TAC.

Any help/guidance as to a "rubber stamped" maximum (or proof that there categorically is not a hard-and-fast maximum) would be much appreciated.

Thanks in advance.

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: