07-09-2015 06:04 AM - edited 03-08-2019 12:54 AM
Hello,
So basically we have a VOIP setup with the PC connecting to the back of the phone. Nothing fancy. I wanted to turn port security on to only allow the phone and the PC to prevent hubs from being connected " authentication port-control auto " and always is showing drop and keep booting the ip phone.
MAC addresses associated with that port that the phones VLAN is showing up in both the VOIP and Data VLAN
(81 is the Data VLAN. 126 is the VOIP VLAN)
Switch01#show mac address-table | i 1/0/8
81 0024.7edb.3336 DYNAMIC Gi1/0/8
81 0060.b955.dec6 DYNAMIC Gi1/0/8
126 0060.b955.dec6 DYNAMIC Gi1/0/8
07-09-2015 09:51 AM
Hi,
Are you trying to deploy dot1x or port security?
07-09-2015 10:05 AM
Hello Reza,
I'm trying run port security.
07-09-2015 10:11 AM
Hi Jose,
Please try following this document. It has some config examples:
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2950/software/release/12-1_14_ea1/configuration/guide/2950scg/swtrafc.html#wpxref86378
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide