cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
586
Views
0
Helpful
3
Replies

IP Addressing on WS-C2960CX-8PC-L

have a customer that has a new WS-C2960CX-8PC-L switch and is having issues assigning IP addresses to interfaces.

The documentation indicates that we should be able to do the following:

conf t

interf gi 0/1

no switchport

ip address 10.10.10.10 255.255.255.0

 

But running 15.2(3)E1 this command is not available.  It looks like the only way around this is to define VLAN interfaces and assign the IP address to the VLAN and then device the phgysical interface to an access vlan.

 

Is this a known bug or is this a documentation bug or both.

 

Thanks

3 Replies 3

Hello

I have never used these switches but have you tried :

 

interf gi 0/1
no switchport
ip address 10.10.10.10 255.255.255.0

res

Paul


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

Paul,

That was part of the configuration.  If you do an "ip ?" under Interface..  address is not an option.

That is just layer-2 switch with LAN Base license.  You can assign an IP to SVI only.

HTH

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco