cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
534
Views
0
Helpful
2
Replies

VPN IPSec SNAT RV320

raul.gadea1
Level 1
Level 1

I have a RV320 router, I created 2 VPN tunnel IPSec but remote LAN only accept 1 IP.
I need connection to remote LAN in all LAN. How I can masquerade for this IP? I do not find SNAT option.

Could I route from other VLAN?

2 Replies 2

mdobiac
Level 3
Level 3

Hello raul.gadea1,

What you will have to do is configure another VPN gateway to gateway tunnel and in the remote subnet setting put in the subnet of the other VLAN.  This will allow the pass through of the subnets over the VPN tunnel/s.

Hope this help,

 

Michael D.

If this post is helpful please rate or mark as correct.

Hi again,

Excuse me maybe not expressed well. I explain better the scenario:

I not have access to remote LAN because is it another company and i can not change this parameters in remote Router. 

I created 2 VPN tunnels gateway to gateway and connection is alive, but they only allow one IP in remote LAN and all traffic of my LAN should be masquerade in this IP.

How can i masquerade all traffic of my subnet in only one IP? 

Thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: