12-01-2015 01:01 AM - edited 03-08-2019 02:54 AM
Hi!
I cannot set the hardware clock on Sup 7L-E (quad VSS) with the following SW version: 03.05.00.E.152-1.E
I have tried these commands, without any effect:
- calendar set
- clock update-calendar
- ntp update-calendar
core1#show ntp ass
address ref clock st when poll reach delay offset disp
+~10.9.47.81 10.9.47.100 4 101 256 377 7.973 1.952 7.484
*~10.9.47.100 84.206.109.4 3 221 256 377 9.000 17.181 18.468
+~10.9.32.53 78.79.86.76 5 52 256 177 9.000 -13.383 2.907
* sys.peer, # selected, + candidate, - outlyer, x falseticker, ~ configured
core1#show clock
11:19:32.736 CET Thu Nov 26 2015
core1#sh clo
06:45:46.181 CET Tue Dec 1 2015
core1#sh cale
11:26:04 CET Mon Feb 25 1974
core1#cale set 06:45:00 01 dec 2015
core1#sh cale
11:26:04 CET Mon Feb 25 1974
Anyone has the same issue?
Thnaks!
12-01-2015 04:10 AM
Try removing ntp server and then set this and save the config.
-4500-1#calendar set 05:38:00 dec 1 2015
-4500-1#show cale
05:38:00 UTC Tue Dec 1 2015
12-03-2015 02:18 AM
Unfortunately it does not helped:
core1#sh run | i ntp
ntp source Vlan999
core1#sh cale
12:26:04 CET-DST Thu Jun 27 1974
core1#calendar set 14:45:00 dec 2 2015
core1#sh cale
11:26:04 CET Mon Feb 25 1974
core1#sh ntp ass
address ref clock st when poll reach delay offset disp
* sys.peer, # selected, + candidate, - outlyer, x falseticker, ~ configured
core1#sh clo
.14:46:15.646 CET Wed Dec 2 2015
core1#sh cale
11:26:04 CET Mon Feb 25 1974
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: