12-01-2015 07:29 AM - edited 03-17-2019 05:04 AM
Hello,
I am looking for the confirmation that DSP transcoding ressources on CUBE ISR G2 can be used by the CUCM in a scenario where the same DSPressources can be used as transcoder for the SIP trunk connection to the ISP ( CUBE acts as SBC too). Is there a possibility to split/dedicate the DSP ressources for the two different functions or I need to even dedicate a separate DSP gateway as a HW CUCM transcoder?
thanks.
Dan P
Solved! Go to Solution.
12-01-2015 08:11 AM
Hi Dan,
If you have enough DSP resources in CUBE to configure transcoding sessions, then you could add that trancoder in an MRG/MRGL and use it in the SIP trunk in CUCM.
HTH
Rajan
Please rate all useful posts
12-01-2015 08:11 AM
Hi Dan,
If you have enough DSP resources in CUBE to configure transcoding sessions, then you could add that trancoder in an MRG/MRGL and use it in the SIP trunk in CUCM.
HTH
Rajan
Please rate all useful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide