cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4342
Views
11
Helpful
4
Replies

Saudi Telecom SIP configuration

certifiedrawi37
Level 1
Level 1

We subscribed to STC SIP service and here is the configuration. 

It works, and I want to share with you my configuration for the voice gateway 

hostname SIP-VG
!
clock timezone GMT 3 0
!
voice-card 0
!
voice service voip
ip address trusted list
ipv4 0.0.0.0 0.0.0.0
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip
fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none
sip
early-offer forced

!
!
voice class uri 6500 sip
host ipv4:10.10.10.1 (STC SIP Registration Server IP)
voice class codec 1
codec preference 1 g711alaw
codec preference 2 g711ulaw
codec preference 3 g729r8
codec preference 4 g729br8
codec preference 5 g723ar53
!
voice class sip-profiles 1000
request INVITE sip-header Remote-Party-ID add "STCETN"
response ANY sip-header Remote-Party-ID add "STCETN"
!
voice translation-rule 1
rule 1 /\(.*\)/ /222\1/ (add 222 before ext for outgoing call)
!
voice translation-rule 2
rule 1 /.*222\(.*\)/ /\1/ (remove 222 to extract ext for incoming call)
!
!
voice translation-profile EXT
translate called 2
!
voice translation-profile Add_Prefix
translate calling 1
!
interface GigabitEthernet0/0
description ***Connected to STC SIP Circuit***
ip address 10.1.1.1 255.255.255.252
!
interface GigabitEthernet0/1
description ***Connected to LAN***
ip address 192.168.1.1 255.255.255.0
!
interface GigabitEthernet0/2
no ip address
shutdown
!
ip route 10.10.10.1 255.255.255.255 10.1.1.2 (Static route for traffic going to STC SIP server)
!
!
!
dial-peer voice 100 voip
description calls to CUCM Publisher
destination-pattern 65..
session protocol sipv2
session target ipv4:192.168.1.10
dtmf-relay rtp-nte h245-signal h245-alphanumeric
codec g711alaw
no vad
!
dial-peer voice 101 voip
description calls to CUCM Subscriber
destination-pattern 65..
session protocol sipv2
session target ipv4:192.168.1.11
dtmf-relay rtp-nte h245-signal h245-alphanumeric
codec g711alaw
no vad
!
dial-peer voice 200 voip
description ***Incoming calls from STC-SBC***
translation-profile incoming EXT
session protocol sipv2
incoming uri via 6500
dtmf-relay rtp-nte h245-signal h245-alphanumeric
codec g711alaw
no vad
!
dial-peer voice 201 voip
description ***Outgoing calls to STC SIP Trunk***
destination-pattern .T
session protocol sipv2
session target ipv4:10.10.10.1:5060
dtmf-relay rtp-nte h245-signal h245-alphanumeric
codec g711alaw
fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none
no vad
!
dial-peer voice 300 voip
description ***Inbound Dialpeer from CUCM to GW***
translation-profile incoming Add_Prefix
session protocol sipv2
incoming called-number .
dtmf-relay rtp-nte h245-signal h245-alphanumeric
codec g711alaw
fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none
no vad

4 Replies 4

Dennis Mink
VIP Alumni
VIP Alumni

nice one!   great for future reference.

Please remember to rate useful posts, by clicking on the stars below.

El4azlongy
Level 1
Level 1

How are u Rawi

I Need your help Please, 

Our company received This  configuration to us and I don't know How to configure it? and what is the required Cisco Router to buy for this configuration?

Thank you   

 

Did you get solution bro,

I'm in same config issue !

Kindly help pls.

NSNaveenKumar
Level 1
Level 1

Kindly me Bro, I'm facing same config issue of STC ISP configuration on my Cisco 4331 ISR.

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: