02-06-2016 02:57 PM
I am in desperate need to get this working asap, so please help me in anyway you can...
I enabled SNMP on my RV215W and chosen all versions; 1, 2c and 3 but cannot get a response from the router. When I use GetIF, I don't get a response and when I check the reachability tab, only port 80 is open and nothing else (port 161 for SNMP is closed).
Also, when I add the router to cacti, I get SNMP error. Bearing in mind that my raspberry pi (on the same network) works fine in GetIF and cacti.
I even disabled the firewall just in case, still not working.
Also, I tried various firmwares, the original firmware that came with it, v1.0 and then upgraded to v 1.3.0.7 and downgraded to v 1.2.0.15 still no joy.
Please help!!!
02-09-2016 06:40 AM
No one is experiencing similar issues?? No one knows how to fix it??
08-23-2016 08:32 AM
I got the same problem too. The user manual suggested that the device only used SNMP v3, i tried v3 but it still does not work.
08-23-2016 08:46 AM
You are absolutely right in saying it is only V3. As I missed that from the "brochure" and it gave me nightmares...
Anyway, it definitely can do SNMP V3 but you have to play around with the encryption settings. I believe (if my memory serves right), only 1 type of encryption level works. I think it might be the 128...
Anyway, experiment with no encryption at all first and increase the level step by step..
P.S. I ended up getting another router from Cisco as this one gave me too much headache...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: