cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1942
Views
0
Helpful
1
Replies

Port channel group SG500

jbpollard
Level 1
Level 1

For some reason my configuration doesn't show the native vlan as 100 or 100 in the allowed vlan list. Is this because its my default vlan?

Just noticed I'm loosing connection randomly from this switch to my network. Both sides of the port group are configured as a trunk with all vlans.

interface gigabitethernet1/1/49
channel-group 1 mode on
!
interface gigabitethernet1/1/50
channel-group 1 mode on
!
interface Port-channel1
spanning-tree link-type point-to-point
switchport trunk allowed vlan add 41,200,300,400
switchport trunk native vlan 1
macro description switch
switchport default-vlan tagged
!next command is internal.
macro auto smartport dynamic_type switch


switch32f1d0#conf
switch32f1d0(config)#int port-channel 1
switch32f1d0(config-if)#switchport trunk native vlan 100
Port Po1: The native VLAN can not be set to the Default VLAN while the Default VLAN is tagged.

1 Reply 1

Luis Gradyz
Cisco Employee
Cisco Employee

Hello 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Switch products supported in this community
Cisco Business Product Family
  • CBS110
  • CBS220
  • CBS250
  • CBS350
Cisco Switching Product Family
  • 110
  • 200
  • 220
  • 250
  • 300
  • 350
  • 350X
  • 550X