cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
854
Views
0
Helpful
1
Replies

RV320 and open ports

seth
Level 1
Level 1

I went to grc.com and did a Shields up test on one of my boxes....
The server is translated to a Public IP address, which Shields up reports that correctly.

When it does the scan of the open ports, it is showing the following ports open:
135
139
445
1025

I tried creating a Firewall rule to deny any traffic going to my ext. IP address, that matches those ports....
Reran the scan and they still show open....

Anyway to stop this?

1 Reply 1

Luis Gradyz
Cisco Employee
Cisco Employee

Hello seth@d2ms.com,

In order to isolate the issue let me ask you, Is the RV320 behind another device? do you have that public IP address configured on the RV320's WAN? 

In any case, please go to Setup--->Forwarding and verify if there is any forwarding rule configured in the Port Range Forwarding Table, if there is you can delete it, after that those ports should not be open.

Have a great day!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: