cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3099
Views
0
Helpful
4
Replies

enable interface

amrelquasaby
Level 1
Level 1

I am working on cisco WS-C6513 with Version 12.2(17r)S4,

And created a layer 2 vlan, and an interface vlan, But when I try to enable the interface vlan, I didn't get any response.

lab6513(config)#vla 200
lab6513(config-vlan)#name temp
lab6513(config-vlan)#exit
% Applying VLAN changes may take few minutes. Please wait...

lab6513(config)#interface vla 200
lab6513(config-if)#ip add 10.255.255.201 255.255.255.0
lab6513(config-if)#no shut
lab6513(config-if)#
lab6513(config-if)#
lab6513(config-if)#
lab6513(config-if)#exit
lab6513(config)#do sh run int vl 200
Building configuration...

Current configuration : 76 bytes
!
interface Vlan200
ip address 10.255.255.201 255.255.255.0
shutdown
end

The interface still shutdown, 

lab6513(config)#do sh interface vl 200
Vlan200 is administratively down, line protocol is down
Hardware is EtherSVI, address is 0019.0753.5180 (bia 0019.0753.5180)
Internet address is 10.255.255.201/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not supported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 packets output, 0 bytes, 0 underruns
0 output errors, 1 interface resets
0 output buffer failures, 0 output buffers swapped out

Please advise.

4 Replies 4

pwwiddicombe
Level 4
Level 4

Do you have any live ports in the associated vlan 200 at all?  I would have thought that the vlan would be Admin up, but line protocol down.

Thanks guys,, 

It was a secure vlan by the FWSM

Furose M
Level 3
Level 3

do you have any other interface who has ip address in "10.255.255.0 255.255.255.0" subnet?

Thanks guys,, 

It was a secure vlan by the FWSM

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: