cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
388
Views
0
Helpful
5
Replies

Unable to complete CIM&P 11 subscriber node install

jpetty002
Level 1
Level 1

Unable to complete CIM&P 11 subscriber node install, below is the error observed

5 Replies 5

Suresh Hudda
VIP Alumni
VIP Alumni

Have you added this in cucm publisher as a subscriber?

Is cucm publisher is synced with ntp server ?

Suresh

Yes both have been done

Yes both have been done

With this I am assuming that you have disabled the LRO as well as followed the workaround mentioned in defect. If that is correct, then contact TAC so that they can take diagnostic dump failure logs and take it from there

Regards

Deepak

I was just checking earlier discussion where installation of IMP sub was failing due to DNS reachability

https://supportforums.cisco.com/discussion/12987926/imp-subscriber-installation-fail-reason-cannot-validate-imp-pub

Just have a look else u can approach TAC.

regds,

aman

Deepak Rawat
Cisco Employee
Cisco Employee

Try disabling the LRO option in the ESXi host configuration followed by ESXi host reboot. Refer below doc for the same and this issue should be fixed then.

https://supportforums.cisco.com/document/95886/disable-lro-ucs-uc-application-deployments

http://docwiki.cisco.com/wiki/Disable_LRO

Take a note of the below defect as well and then perform the workaround mentioned there in case if disabling LRO doesn't help. Though the defect goes only till 10.5(2) but it is still applicable for v11 as well

https://bst.cloudapps.cisco.com/bugsearch/bug/CSCur94973/?referring_site=bugquickviewredir

Regards

Deepak

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: