Hi Reza,

Thanks for the reply ,

My Chasis is 6509 with catOS

BOOT variable = bootflash:cat6000-sup2k8.8-4-5.bin,1;bootflash:cat6000-sup2k8.7-5-1.bin,1;

WS-C6509 Software, Version NmpSW: 8.4(5)
Copyright (c) 1995-2005 by Cisco Systems
NMP S/W compiled on Aug  3 2005, 12:01:19

System Bootstrap Version: 7.1(1)
System Boot Image File is 'bootflash:cat6000-sup2k8.8-4-5.bin'

Existing Hardware  detail is

NAME: "Chassis", DESCR: "Cisco Systems WS-C6509 9 slot switch" PID: WS-C6509 , VID: , SN: X.X.X.X.X.X.X

Switch > (enable) sh module
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
1 1 2 1000BaseX Supervisor WS-X6K-SUP2-2GE yes ok
2 2 48 10/100BaseTX Ethernet WS-X6148-45AF yes ok
3 3 48 10/100BaseTX Ethernet WS-X6148-45AF yes ok
4 4 48 10/100BaseTX Ethernet WS-X6148-45AF yes ok
5 5 48 10/100BaseTX Ethernet WS-X6148-45AF yes ok
6 6 48 10/100BaseTX Ethernet WS-X6148-45AF yes ok
7 7 48 10/100BaseTX Ethernet WS-X6148-45AF yes ok
8 8 48 10/100BaseTX Ethernet WS-X6148-45AF yes ok
9 9 48 10/100BaseTX Ethernet WS-X6148-45AF yes ok

Mod Sub-Type                Sub-Model          
--- ----------------------- ---------------
1   L3 Switching Engine II  WS-F6K-PFC2       
2   IEEE InlinePower Module WS-F6K-FE48-AF    
3   IEEE InlinePower Module WS-F6K-FE48-AF     
4   IEEE InlinePower Module WS-F6K-FE48-AF     
5   IEEE InlinePower Module WS-F6K-FE48-AF    
6   IEEE InlinePower Module WS-F6K-FE48-AF     
7   IEEE InlinePower Module WS-F6K-FE48-AF     
8   IEEE InlinePower Module WS-F6K-FE48-AF     
9   IEEE InlinePower Module WS-F6K-FE48-AF