cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
223
Views
0
Helpful
1
Replies

Rogue AP view in GUI

ptilling
Level 1
Level 1

I have a 5508 series WLC running 8.0.135.0. I have noticed that the rogue APs do not show up in the GUI until you run #show rogue ap sum in the CLI. Then again to get an update you must run the CLI command.

Has anyone noticed this?

1 Reply 1

marce1000
VIP
VIP

 - Good call, I saw the issue already in the past (not all rogue's listed in the GUI); in my case I only get 20 , of the 222 active. After your command I can see 111 in the GUI, exactly half so still not all of them.  Probably a bug, advising to report to TAC.

M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: