Problems with WLC 2504 and AP 700

gayala00111 · ‎07-25-2016

Hi everyone! I have an issiue with my WLC, when I configure the interfaces and te AP´S for the firt time the will work well, but the problem is when I reset the WLC I can´t see the Access Point Anymore.

Only if I reset the WLC I can see them again.

Can you help me with this?

Leo Laohoo · ‎07-25-2016

but the problem is when I reset the WLC I can´t see the Access Point Anymore.

Post the complete output to the following commands:

1. WLC: sh sysinfo;

2. WLC: sh time

Only if I reset the WLC I can see them again.

Are the APs directly connected to the controller?