Switchover Commend with Single 6800 and dual supervisor

gokhana · ‎08-24-2016

Hi,

We are using a single 6800 series with VSS configuration for Instant Access. We got 2 supervisor on 6800. My question is how can we switchover from these supervisor. "supervisor switchover" command is not working, it says standby is not active.

Thanks.

Jose Solano · ‎08-24-2016

Hi,

Check this out:

You can initiate a z-switchover by entering the redundancy force switchover command on the in-chassis active supervisor engine.

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SX/configuration/guide/book/vss.html#wp1204229

HTH,

Leo