09-21-2016 02:12 AM - edited 03-01-2019 12:53 PM
Hi Guys ,
Firstly , thanks in advance for your comments .
I'm a cisco worker .
A client bought UCS C-460 with 12 SSD , 3TB each . It got no RAID controller, it is just JBOD .
I'm trying to install RHEL 7.2 on it , like the user asked [he asked that 100GB will go to " / " , and keep the rest un allocated ]
I have some issues with it .
I installed it , but something went wrong ... don't know what ...
the installation seems to be fine , but after the reboot , nothing booted up ...
I suspect that some configuration via CIMC is wrong .
please take a look on the screenshot , and let me know and if it's fine , and if you can aim me to something that I might did wrong .
thanks a lot !
Solved! Go to Solution.
09-21-2016 11:11 AM
Greetings.
Since boot disk is larger than 2TB, you are required to use UEFI.
Please make sure you have the following:
You may need to reinstall again, if it wasn't set to UEFI.
Thanks,
Kirk....
09-21-2016 11:11 AM
Greetings.
Since boot disk is larger than 2TB, you are required to use UEFI.
Please make sure you have the following:
You may need to reinstall again, if it wasn't set to UEFI.
Thanks,
Kirk....
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: