ā10-27-2016 06:20 AM - edited ā07-05-2021 06:03 AM
Hi all I hope you can help me I have a faulty Cisco AIR-LAP1143N-E-K9 wireless access point that I got second hand and I was wondering if there is any way to fix it before I try to send it back.
When I first start the AP I hold in the mode button until it turns red then when it has finished booting I use the reset command (I have done this to over 20 APās recently all worked fine) but this access point just loops constantly and never appears in the admin interface.
I have attached the full log of what happens when viewing in putty.
Any information you can give me will be very much appreciated.
Regards,
John
ā10-27-2016 06:17 PM
ā11-03-2016 09:04 AM
Hi Brett
Thanks for the reply will try this very much appreciated.
Regards,
John
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: