Hello everyone,

Let me provide some information regarding to my question.

! Dial-peer configuration:
dial-peer voice 10 voip
 destination-pattern 2002
 session protocol sipv2
 session target ipv4:172.16.16.1
!
Calling from C7962(TypeB/SCCP:DN5001 (redialing, from the call-list or onhook&dial: EN BLOC) to DN2002.
I have no doubts - DN5001 is sending it as Enbloc, not on digit-by-digit basis.
Checked by - debug ephone message:  SkinnyMessageID = StationEnblocCallMessageID(calledParty=2002)

At the same time, Dial-peer hunting is performing based on digit-by-digit.
I can prove it by - debug voip dialpeer inout:
Match Rule=DP_MATCH_DEST; Called Number=2
Match Rule=DP_MATCH_DEST; Called Number=20
Match Rule=DP_MATCH_DEST; Called Number=200
Match Rule=DP_MATCH_DEST; Called Number=2002
   Result=SUCCESS(0)
   List of Matched Outgoing Dial-peer(s):
     1: Dial-peer Tag=10

Can you confirm that Dial-peer selection for SCCP phones, will be always done based on digit-by-digit analysis?
Always, I mean despite on how the digits were collected (enbloc or digit-by-digit), firmware, IOS version or phone model.
Please give me more information about enbloc with SCCP, thank you in advance.

--
Have a nice day,
Dmitry