Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1300
Views
0
Helpful
1
Replies

HWIC-4ESG - do they support Port-Channel?

Go to solution
rlarkins2015
Level 1
Level 1

‎01-05-2017 02:31 PM - edited ‎03-08-2019 08:48 AM

I see from the document "Understanding Layer 3 Etherchannel Support on the Cisco ISR" that the HWIC-4ESW does NOT support port-channel configuration.    I was wondering if that is the same for the HWIC-4ESG in a C3945?

So far, my configuration tests tell me that it's not supported... 

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Philip D'Ath
VIP Alumni
VIP Alumni

‎01-05-2017 03:32 PM

Not supported.

You can only do port-channel on the built in ports, only layer 3 port-channel, and it is a "manual" port-channel.

View solution in original post

0 Helpful
1 Reply 1

Go to solution
Philip D'Ath
VIP Alumni
VIP Alumni

‎01-05-2017 03:32 PM

Not supported.

You can only do port-channel on the built in ports, only layer 3 port-channel, and it is a "manual" port-channel.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card