×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

No POE

Unanswered Question
Feb 13th, 2017
User Badges:

I have a SG300-10MP that is connected to a Ubiquiti Gateway switch on port 1. Even though I have POE enabled the ports do not provide power over ethernet, otherwise they function normally. I have even reset the switch to the default settings without any luck. See image below for settings.

I have a second SG300-10MP connected to the one above on port 2. When I plug in the same POE device to that one it provides power.

Is there anything I have set up incorrectly?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion