Wireless Autonomous AP

Unanswered Question
Apr 19th, 2017
User Badges:

Hi,

I have configured one of my 1700 AP in stand alone mode with one SSID but we are able to see two SSIDs.

Ex: I have created "wireless-network" SSID but "wireless-network_1" SSID also broadcasting by the same AP.

Kindly help us to resolve the issie.


Thanks and regards,

Ashok.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
aleopoldie Wed, 04/19/2017 - 03:42
User Badges:

Hello S.ashok,


This is how SSIDs are working on an autonomous AP.

First, you create your SSID :

Example :

conf t
dot11 ssid wireless-network
authentication open
authentication key-management wpa version 2
guest-mode
wpa-psk ascii 0 welcome

And then you link this SSID to the dot11radios 0 and 1 :


conf t
interface dot11Radio 0
encryption mode ciphers aes-ccm
ssid wireless-network

interface dot11Radio 1
encryption mode ciphers aes-ccm
ssid wireless-network


Run the command "show run" and check if on your dot1radios you have your SSID "wireless-network_1". 

From there, you can go in the dot11radios and put a "no ssid wireless-network_1"

Cheers,

Alex-


S.ashok S Wed, 04/19/2017 - 04:07
User Badges:

Hi,

Thank you for your reply.

It seams it is already there. Please find radios configuration as below.

interface Dot11Radio0
no ip address
!
encryption mode ciphers aes-ccm tkip
!
ssid wireless-network
!
antenna gain 0
stbc
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
interface Dot11Radio1
no ip address
!
encryption mode ciphers aes-ccm tkip
!
ssid wireless-network
!
antenna gain 0
peakdetect
dfs band 3 block
stbc
channel dfs
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding


Thanks and regards,

Ashok 

S.ashok S Wed, 04/19/2017 - 04:16
User Badges:

Hi,

Showing two SSIDs as below

wireless-network

&

wireless-network 2

But I have configured only one which is first one.


Thanks and regards,

Ashok

S.ashok S Wed, 04/19/2017 - 04:19
User Badges:

Hi,

I have tried to remove second one from radio but showing "unknown ssid" as it is not appearing.

Thanks and regards,

Ashok.

aleopoldie Thu, 04/20/2017 - 04:52
User Badges:

Hello Ashok,


If you try to disable the SSID from the interface dot11radio 1, the SSID "wireless-network_1" is still broadcasted ?

Alex-

Actions

This Discussion

Related Content