Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
357
Views
0
Helpful
1
Replies

Enable gigabit ethernet interfaces on WS-X45-Sup8L-e module

bvanovereem
Level 1
Level 1

‎04-21-2017 04:29 PM - edited ‎03-08-2019 10:17 AM

I have 10 new 4506E chassis with WS-X45-SUP8L-E sup module that I need to configure. I do not have 10GB to my Distribution yet. What command do I use to enable the sup's interface to recognize GB instead of 10gb? The sup6 or sup7 command "hw-module uplink gigabitethernet" does not work on the Sup8. My Fw/OS is: 15.1(1r)SG6 / 03.08.03.E

Sw1#sho int status

Port      Name               Status       Vlan       Duplex  Speed Type
Te1/1                        notconnect   1            full   auto No XCVR
Te1/2                        notconnect   1            full   auto No XCVR
Te1/3                        notconnect   1            full   auto No XCVR
Te1/4                        notconnect   1            full   auto No XCVR

Sw1(config)#hw-module ?
  beacon  Apply hw-module command to beacon LED
  module  Individual module in the system
  module  Specify a linecard slot for the hw-module command
  slot    Specify a linecard slot for the hw-module command
  system  Specify the system parameter

Labels:
0 Helpful
1 Reply 1

Reza Sharifi
Hall of Fame
Hall of Fame

‎04-21-2017 06:38 PM

The ports on sup-8 are 1/10. Once you insert a 1Gig SFPs into the port, it should recognized it without needing to use any command.

HTH

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card