cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
592
Views
0
Helpful
1
Replies

Failure source pattern in Cisco Prime Infrastructure 3.1.5

CSCO10902379
Level 1
Level 1

Hi,

Is there a way to edit failure source pattern *not separator, but the pattern itself, to be like this / just Name both for AP and for Controller?

At the moment pattern is:

MAC Address:Name for AP

IP Address:MAC:Name for Controller

both MAC and Name are grey, so I cannot unmark them. Thanks.

1 Reply 1

CSCO10902379
Level 1
Level 1

I have opened TAC case on this and got the answer that this cannot be done (editing failure source pattern).

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: