07-26-2017 02:04 AM - edited 03-19-2019 12:39 PM
Hello All,
I have a Cisco 2901 which I have added to CUCM via the gateway section, using a MAC address off of one its live networked ports.
In my Cisco 2901 I have an FXS card which I have also added to call manager, with a port that I have attached a number to out of my call manager directory ready for the device I will be plugging in.
Aside from testing the device on the day, how can I tell that my router has actually connected properly with CUCM? Is there a show command I can do in the CLI of the device? Will my config trickle down from CUCM to the 2901 in regards to voice-ports ect?
Apologies I haven't done any voice courses or work any advice is greatly appreciated.
Solved! Go to Solution.
07-26-2017 02:35 AM
Hi
For adding it as SCCP see below.
https://supportforums.cisco.com/document/12450616/stcapp-how-configure-fxs-ports-cucm
For MGCP
https://supportforums.cisco.com/document/90521/mgcp-gateway-integration-cucm-and-pstn-service-provider
http://www.cisco.com/c/en/us/support/docs/voice/media-gateway-control-protocol-mgcp/23966-mgcp-pri-cm.html
https://www.youtube.com/watch?v=-QwICmRqfx4
for H323
https://supportforums.cisco.com/document/99806/adding-h323-gateway
https://www.youtube.com/watch?v=q82qf9HJkyw
for SIP trunk
https://supportforums.cisco.com/blog/12108326/implementing-sip-gateways-cucm
What is the purpose of adding this gateway, what are you trying to achieve.
(Rate if it helps)
JB
07-26-2017 02:26 AM
Hi,
How are you trying to add this to CUCM, you would have to choose a protocol
MGCP \ H323 \ SIP ?
JB
07-26-2017 02:31 AM
Hello thanks for your response,
The options I have when adding a device are mgcp and sccp, we use sccp
07-26-2017 02:35 AM
Hi
For adding it as SCCP see below.
https://supportforums.cisco.com/document/12450616/stcapp-how-configure-fxs-ports-cucm
For MGCP
https://supportforums.cisco.com/document/90521/mgcp-gateway-integration-cucm-and-pstn-service-provider
http://www.cisco.com/c/en/us/support/docs/voice/media-gateway-control-protocol-mgcp/23966-mgcp-pri-cm.html
https://www.youtube.com/watch?v=-QwICmRqfx4
for H323
https://supportforums.cisco.com/document/99806/adding-h323-gateway
https://www.youtube.com/watch?v=q82qf9HJkyw
for SIP trunk
https://supportforums.cisco.com/blog/12108326/implementing-sip-gateways-cucm
What is the purpose of adding this gateway, what are you trying to achieve.
(Rate if it helps)
JB
07-26-2017 02:50 AM
Thank-you for your quick responses, this is 100% what I need I believe there is afew commands missing in the router's cli that I hadn't been aware of.
07-26-2017 02:52 AM
Happy to help,
Thanks for updating the post.
JB
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: