05-16-2001 05:02 AM
Hi,
I need to know if:
Cisco 11000 Series of Content Services Switch (CSS)
can be used to do load balancing of Firewall Check Point.
I need to Know the new cisco name of "Arrow point Model CS50".
Thank you.
Monica
05-16-2001 08:38 AM
Monica,
Yes, the Cisco CSS 11000 Series can load balance Check Point Firewalls. There are specific design requirements that are layed out in the documentation.
The Arrowpoint Model CS50 is now:
CSS-11051-AC (8 10/100BASE-TX ports)
CSS-11052-AC (8 10/100BASE-TX ports & 1 1000BASE-SX
05-21-2001 06:14 PM
Hi Monica,
Yes, as Gary has indicated the CSS will work with Checkpoint in a firewall load balancing environment. I have just finished a project in which we were using 2 Nokia IP650's and 4 CSS-150's. I used a configuration fairly similar to the one found in:-
http://www.cisco.com/warp/customer/117/fw_load_balancing.html.
There were a few small gotya's but the whole thing worked quite well.
Regards Brett
03-13-2002 09:23 AM
Hi Gary,
We are looking at using 11151 CSS and IP740's.. Can you send me your email if you dont mind..
thanks
07-02-2001 04:50 AM
The CSS is Checkpoint OPSEC certified, and I also believe there is a possibility of creating a Firewall sandwich, one CSS is requried either side.
03-13-2002 01:22 PM
You might also want to check this out:
http://www.cisco.com/univercd/cc/td/doc/product/webscale/css/css_500/advcfggd/firewall.htm
Your FWLB config will vary depending on which method of redundancy you configure with yout CSSes.
Cheers,
Perry.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide