×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

IP Masquerading on Cisco router

Unanswered Question
dwax Tue, 05/22/2001 - 08:25
User Badges:

why don't you NAT on the Serial interface.

dwax Wed, 05/23/2001 - 10:20
User Badges:

Step Command Purpose

1 .

ip nat pool name start-ip end-ip {netmask netmask | prefix-length prefix-length} Define a pool of global addresses to be allocated as needed.

2 .

access-list access-list-number permit source [source-wildcard] Define a standard access list.

3 .

ip nat inside source list access-list-number pool name overload Establish dynamic source translation, identifying the access list defined in the prior step.

4 .

interface type number Specify the inside interface.

5 .

ip nat inside Mark the interface as connected to the inside.

6 .

interface type number Specify the outside interface.

7 .

ip nat outside Mark the interface as connected to the outside.


Actions

This Discussion