×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

How to access from low security to high security network

Unanswered Question
Aug 15th, 2001
User Badges:

Does any one know if you can access network from low security level to high security level? Not connecting to one host through specific port in higher security level but able to ping the entire high security level from dmz. I'm using PIX 5.2 version.


Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jbaigorr Wed, 08/29/2001 - 22:45
User Badges:

Oops! I over looked your primary question. Make sure you don't have a static from the dmz to the entire network on the inside interface and make sure you don't have a conduit icmp any any configured.

Actions

This Discussion