09-24-2001 07:57 PM - edited 03-01-2019 06:46 PM
I am trying to simulate a T1 link (not using DCE/DTE cable), by using a T1 CSU/DSU WIC on one router and on another router I am using an external third party CSU/DSU (Verilink). To simulate the service provider network, I connect the RJ45 cable between the two CSU network connection as follows
1-4
2-5
4-1
5-2
The line comes up, but the protocol doesn't??
Encapsulation on both serial port = hdlc
bandwith on both = 1544
WIC-T1 is line time, full rate T1, ESF/B8ZS
External CSU is internal timed, ful rate t1, ESF/B8ZS
09-27-2001 03:59 AM
but in this simulation, who is providing the clock for the circuit????...
ramesh
10-01-2001 06:03 AM
yeps, you should configure clock rate
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: