personal assistant

Unanswered Question
Oct 2nd, 2001
User Badges:

I am having a problem accessing my personal assistant server. Everytime I dial the PA number, I get fast busy.

I've configured everything according to the admin guide but when I look at the CTI routepoint in the cm admin screen, the status says "not found" & there is no IP address listed. I've checked that the PA server has the same directory number listed in the route address field.

Any suggestions ?


thanks


Rob

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Version may make all the difference for you. What version Call Manager and Personal Assistant are you running?


Personal Assistant 1.1a is reported not to work with CCM versions lower than 3.0. Similarly, Personal Assistan 1.2 has only been tested and confirmed to work with CCM 3.1(1). If you're using the right versions, then I'm not sure what the problem is because we're having the same problem and are awaiting a software upgrade for Personal Assistant.

rvincent Wed, 10/03/2001 - 06:37
User Badges:

I am trying to run Personal Assistant 1.1(1a) with call manager 3.1(1).

dgoodwin Wed, 10/03/2001 - 08:23
User Badges:
  • Cisco Employee,

Rob,


CallManager 3.1(1) requires Personal Assistant 1.2(x) since the JTAPI versions are different.


PA1.1 is only for use with CM3.0(x) where x is >= 9.


If you have the full blown PA1.1 (not the directory dialer) then you can download the PA1.2 upgrade from the Software Center. The demo version of PA1.2 (directory dialer) should be on CCO soon.

rvincent Wed, 10/03/2001 - 11:55
User Badges:

Dave:


thanks. But what do you mean by the directory dialer version? I believe I have the full version but I don't see the 1.2 version on the software center.


Rob


dgoodwin Wed, 10/03/2001 - 12:02
User Badges:
  • Cisco Employee,

The directory dialer version only lets you call PA directly, it doesn't have the ability to intercept calls and route them based on criteria such as Caller ID and time of day, etc.


You have to login to CCO before you will see PA1.2 in the Software Center. It's at:


http://www.cisco.com/cgi-bin/tablebuild.pl/assist

Actions

This Discussion