10-05-2001 11:10 AM - edited 03-12-2019 12:49 PM
I'm trying to figure out how I can tell how many calls my CallManager 3.0(11) has in progress on a cat 6500.
Is there an OID I can poll to tell me how many calls are active on a WS-X6608-T1 port?
I'm running hybrid IOS, CatOS on the switch and I can only access SNMP via the supervisor engine's IP. Do I need to configure SNMP for each of the 6608's addresses? If so, how?
Thank you for any suggestions.
10-11-2001 07:06 AM
This might be what you are looking for http://www.cisco.com/warp/public/180/prod_plat/cust_cont/icm/reporting_data_categories.html
10-12-2001 05:16 AM
Thanks for the response but not exactly what I was looking for.
From our CallManager, we can route outbound calls to an as5300 or a ws-x6608-T1 module in our catalyst switch.
On the 5300 I can use an SNMP tool to get the value of OID 1.3.6.1.4.1.9.10.19.1.1.4. The value of this OID is the number of voice channels currently in use.
On the Catalyst the command SHO PORT VOICE ACTIVE will report the number of calls active in the Total column. I need an OID for the Cat that will return the same information.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: