×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

SRST Latency threshold settings

Unanswered Question
Oct 26th, 2001
User Badges:

Hi,


Is there a way to configure on SRST router that if Latency is more than 300ms then switch over to failover situation and use local dial tone.


thanks,



Arsalan

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
dgoodwin Fri, 10/26/2001 - 09:11
User Badges:
  • Cisco Employee,

No way that I know of. It's really up to the phone to decide it is not getting responses from the CallManager, and then it will try to register with its default gateway.


If you are getting that much latency then either you are having some kind of telco circuit or WAN issues that need to be addresses, or your end to end QoS is not setup properly, or you have something wrong with the CallManagers, etc.

Actions

This Discussion