×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

VPN with NAT Static to dynamic an callback

Unanswered Question
Oct 30th, 2001
User Badges:

I have the following problem:


we wont to build an VPN with Cisco 2651 Router and IPSec Software into the headquarter and 2621 Router with the same Software on the other sites.


We have an 128 kb leased line with an static IP Address in the headqurter and an ISDN Bri line with dynamic address on the other site.


The requirement of the network is, that the headquarter on must do the call on an seperatly Bri Port to the other side. The 2621er router must call the Internet and make also an tunnel to the headquater.


Can you help me to configure the routers? What do you wont to know about the network.


Thank you very much for your help.


Oliver Kutschenreuter

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ciscomoderator Sun, 11/04/2001 - 18:40
User Badges:
  • Gold, 750 points or more

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen


If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.


Actions

This Discussion