×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Access List - IP Division for BGP Load Sharing

Unanswered Question
Nov 2nd, 2001
User Badges:

Using a 7204 router, we have six T-1's of Internet, all with BGP


Looking for suggestions as to how to divide the the IP ranges between the six providers; using the access lists and route maps.


Thanks!




  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ciscomoderator Thu, 11/08/2001 - 12:09
User Badges:
  • Gold, 750 points or more

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen


If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.


cybrgenx Thu, 11/08/2001 - 13:16
User Badges:

It might help if you clear up the reasons for the division, like... what are you using the t1's for?, just internet access? (though 6 t1's for internet access seems a little excessive, so that can't be it!)? internet services? do you wish to send on 3 t1's and receive on the other 3?



seilsz Thu, 11/08/2001 - 15:04
User Badges:
  • Bronze, 100 points or more

Please provide additional information regarding your request:


- What route(s) are the providers advertising to you? Do you have a choice?


- What IP addresses do you use to connect to the Internet? Did each of the providers provide you with a block of addresses?

Actions

This Discussion