×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Transfer calls with H.323 gateway

Unanswered Question
Nov 28th, 2001
User Badges:

I have a BRI port in a 3600. When I transfer an external call (or try to put this call on hold), the call shutdown. But with internal calls I dont have problems. Somebody knows what is happening?


Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
rbewlay Wed, 11/28/2001 - 23:01
User Badges:

The most likely problem is a version of IOS prior to 12.?? which does not support H.323v2. Without this functionaly you must invoke MTP for the gateway in the appropriate setup screen for the H.323 config. Check the supported features.

j.recio Thu, 11/29/2001 - 01:17
User Badges:

Hi.


My IOS version is 12.1(5)YD2. With older versions we dindnt have this problem. But I must use this version because in the future I will need SRST.


Thanks.


msolak Thu, 12/06/2001 - 02:47
User Badges:
  • Silver, 250 points or more


Check the " Media termination Point Requiered " box on the Gateway.


Good Luck


mehmet

mdevoscpq Thu, 12/06/2001 - 03:37
User Badges:

If you are using CM 3.1 with MOH it is most likely a codec problem.


Service>Service Parameters>"YourServer">Cisco IP Voice Media Streaming App>DefaultMOHCodec

Make sure you either select all the codecs or specifically the one you are using.


Take it easy.

Actions

This Discussion