×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

SRST - fast busy on outbound after 1 digit

Unanswered Question
Nov 29th, 2001
User Badges:

CM 3.1(2c), SRST on 2620 with PRI. I followed all the sample configs. Inbound calls work fine. When I try to make an outbound call, I get fast busy after the first digit(no matter what I dial).


Here is config:

dial-peer voice 1 pots

incoming called-number .

destination-pattern 9.

progress_ind progress enable 8

progress_ind connect enable 8

direct-inward-dial

port 1/0:23


call-manager-fallback

ip source-address 10.7.199.3 port 2000

max-ephones 24

max-dn 48

dialplan-pattern 1 630754.... extension-length 4

default-destination 3204

voicemail 5000

Thanks in advance.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ehaseki Thu, 11/29/2001 - 22:57
User Badges:

Hi,

In the Dial-peer pots configuration you should write "destination-pattern 9T" instead of "destination-pattern 9.". Hope it helps.

ERDEM...

v.kangin Fri, 11/30/2001 - 01:01
User Badges:

or try this:


destination-pattern 9


with no dot. you only want the 9 to get the line for you.


tvanblon Fri, 11/30/2001 - 12:33
User Badges:

You must be running IOS 12.1(5YD) code, which does not support PRI with SRST. Upgrade to 12.2.2(XB).

Actions

This Discussion