×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Problem in 3.1(2c)

Unanswered Question

Hi all,


Recently, we upgraded from 3.0(9) to 3.1(2c), everything looks fine so far, but there is one problem in IP Phone 7960. When I hit the "directory" button, it shows "Host not found", usually will show "missing call", "receieved call" and "placed call". However, and then I hit "scroll button" on the IP Phone, it shows "missing call", "receieved call" and "placed call".


Is there anyone call fix this problem without hit "scroll button" or "host not found" message??


Thanks a lot

Ken

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
i.fouraki Fri, 11/30/2001 - 07:19
User Badges:

Hi,

I had the "Host not found" incident when in lab environment I was using DNS and the remote site did not have acces to the DNS server. So when I changed the name of the CM with its IP address in the enterpise parameters and in the name of the CM, it worked. I could see the directories from the remote site's IP Phone too. I do not know if this helps you. Check also the status messages, you may see something there.

Regards,

Yanna

jtvedte Fri, 11/30/2001 - 20:41
User Badges:

Ken,


Go into enterprise parameters - and check the URL for the Directories....


I bet that you have the server name listed in the URL - change it to the IP address of the server...


i.e. http:///CCMCIP...

change to: http:///CCMCIP....


Hope that helps,


John

jtvedte Fri, 11/30/2001 - 21:11
User Badges:

One other thing - stop and restart the TFTP service

Actions

This Discussion