×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

2912 MFXL and GBIC Modules.

Unanswered Question
Dec 4th, 2001
User Badges:

Hi im using the 2912 MFXL switch with the IOS version 12.0(5.2)XU.When i install the Gbic module it gives the following error message.Can anybody help to resolve.Does it require a upgrade of IOS.

Thanks.

Module Ports Model HW Version SW version

WS-X2931-XL 1 xxxx xxxx




  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
v.j Wed, 12/05/2001 - 01:54
User Badges:

Find out that the vlan in 2912 was configured on vlan 1 with ip 20.10.70.15 255.255.254.0 but the same network is configured on the MSFC for vlan 70.So after changing the config in the 2912 for vlan 70 which was not there initially, it worked fine.But still i get the Hardware and s/w version of 1000baseSX listed as XXXX,XXXX.

But it works now.


bsivasub Sat, 12/08/2001 - 10:19
User Badges:

I think these modules are not Hot swappable. Try powering down the whole switch and reseat the module or try in a different slot.

Actions

This Discussion