×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

SNMP traps for a given destination

Unanswered Question
Dec 6th, 2001
User Badges:

Hello,


Can anybody advise me how can I provide ONLY LinkUP/DOWN traps for a given destination, while I'm getting all the traps? I have the current config and here let's say I'd like to add a new trap desination.



snmp-server engineID local XXXXXXXXXX

snmp-server community XXXXXXXXXXX

snmp-server trap-source XXXXXXXXXXXX

snmp-server location XXXXXXXXXXXXXXXXXXXXXX

snmp-server contact XXXXXXXXXXXXXXXXXX

snmp-server enable traps config

snmp-server enable traps envmon

snmp-server host AAA.BBB.CCC.DDD public

snmp-server tftp-server-list 10

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jegrimm Thu, 12/06/2001 - 13:42
User Badges:

Hello,

I am not sure which versions but IOS 12.2(1) allows:

snmp-server traps enable linkup linkdown


Good Luck!

Jim

tszombathy Fri, 12/07/2001 - 03:13
User Badges:

Hi Jim,


I run c2600-is-mz.121-11.bin and here I don't have the possibility you mentioned. Do you have any other idea?

I find out that the command snmp trap link-status issued on a per interface basis produces the traps but I can't see how can I direct only theese to the given destination (kind of an access list to associate???).


Regards,

Tibor

jegrimm Wed, 12/12/2001 - 08:16
User Badges:

at the end of the

snmp-server host A.B.C.D community


there might be an opportunity to add trap types...Not sure on a 2600...Also up/down is under snmp trap types but this include authentication and cold/warm start stuff...


Jim

Actions

This Discussion