SNMP traps for a given destination

tszombathy · ‎12-06-2001

Hello,

Can anybody advise me how can I provide ONLY LinkUP/DOWN traps for a given destination, while I'm getting all the traps? I have the current config and here let's say I'd like to add a new trap desination.

snmp-server engineID local XXXXXXXXXX

snmp-server community XXXXXXXXXXX

snmp-server trap-source XXXXXXXXXXXX

snmp-server location XXXXXXXXXXXXXXXXXXXXXX

snmp-server contact XXXXXXXXXXXXXXXXXX

snmp-server enable traps config

snmp-server enable traps envmon

snmp-server host AAA.BBB.CCC.DDD public

snmp-server tftp-server-list 10

jegrimm · ‎12-06-2001

Hello,

I am not sure which versions but IOS 12.2(1) allows:

snmp-server traps enable linkup linkdown

Good Luck!

Jim

tszombathy · ‎12-07-2001

Hi Jim,

I run c2600-is-mz.121-11.bin and here I don't have the possibility you mentioned. Do you have any other idea?

I find out that the command snmp trap link-status issued on a per interface basis produces the traps but I can't see how can I direct only theese to the given destination (kind of an access list to associate???).

Regards,

Tibor

jegrimm · ‎12-12-2001

at the end of the

snmp-server host A.B.C.D community

there might be an opportunity to add trap types...Not sure on a 2600...Also up/down is under snmp trap types but this include authentication and cold/warm start stuff...

Jim