×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Defining VTP Domain on 2924

Unanswered Question
bsivasub Tue, 12/18/2001 - 14:13
User Badges:

you don't need to go into configuration mode, you need to vlan configuration mode (straight from the enabled mode)

switch#vlan database

switch(vlan)#vtp domain


You type 'exit' to save the changes and get back to enable mode.

donalwil Wed, 12/19/2001 - 11:34
User Badges:

Hi


Here is a link that will walk you through the set up. It should be very helpful in setting up VTP, Vlans, VMPS and Trunk Links. have a good day

Donald Williams

CCNA


http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35wc/sc/swgvlans.htm#xtocid1196610

Beginning in privileged EXEC mode, follow these steps to configure the switch for VTP server mode:


Command Purpose

Step 1

vlan database

Enter VLAN database mode.

Step 2

vtp domain domain-name

Configure a VTP administrative-domain name.


The name can be from 1 to 32 characters.


All switches operating in VTP server or client mode under the same administrative responsibility must be configured with the same domain name.

Step 3

vtp password password-value

(Optional) Set a password for the VTP domain. The password can be from 8 to 64 characters.


If you configure a VTP password, the VTP domain does not function properly if you do not assign the same password to each switch in the domain.

Step 4

vtp server

Configure the switch for VTP server mode (the default).

Step 5

exit

Return to privileged EXEC mode.

Step 6

show vtp status

Verify the VTP configuration.


In the display, check the VTP Operating Mode and the VTP Domain Name fields.



Actions

This Discussion