01-16-2002 07:25 PM - edited 03-12-2019 02:04 PM
Does anyone know if it is possible to disable inbound caller ID on Call Manager 3.1(2c) with a 6608 gateway using a PRI? If so, how? The presentation bit takes care of the outbound, but my client wants to block inbound CLID as well.
Thanks
01-25-2002 01:40 PM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
01-27-2002 08:42 PM
There is a box under the route pattern setup that will let you do that. Go under the route patterns and check that box and then go to the users in question and put in a transform mask wild card. I think it is * . Email me if you have a problem.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide